The Apple Vision Pro has a very good display. That’s the big takeaway from iFixit’s second teardown video on the headset (with accompanying blog), as the team found the dual MicroOLED panels inside are the densest they’ve ever seen at 3,386 pixels per inch (ppi). That doesn’t quite put the Vision Pro at 4K resolution, but it’s close. (iFixit notes that the consumer standard for 4K UHD is 3,840.) This is the benefit of using MicroOLED and is also a huge part of why the Vision Pro is so costly.

Compared to other VR headsets, there’s no contest here. iFixit points out that the Meta Quest 3 sits at about 1,218ppi, while the HTC Vive Pro is even less dense at around 950ppi. And your average phone is only going to be in the mid-100s. (iFixit notes the 15 Pro Max is at 460ppi.)

Lenses and a MicroOLED display from Apple’s Vision Pro headset.
Image: iFixit

But as iFixit also writes, pixels per degree is an important number — your eyes are so close to the screen that things can get pixelated as you look over to the side of the screen when the number of horizontal pixels per degree (ppd) of viewing angle is low enough. iFixit says it estimates the Vision Pro to be about 34ppd, which is lower than the 94 and 95ppd ratings you’d see in the iPhone 15 Pro Max at a foot away or a standard 65-inch 4K TV at 6.5 feet away, respectively.

Looking at the battery pack, iFixit found that Apple appears to be limiting the charge to about 80 percent of the total actual capacity, finding that the three roughly iPhone-size batteries packed inside have a total 46.08Wh capacity. (Apple labels it as 35.9Wh.) The big Lightning connector is used to output a non-USB standard 13 volts, and iFixit also found the accelerometer that activates the pack’s charge LED as well as temperature sensors, which could also help keep it from getting uncomfortably hot while in users’ pockets.

The team also published findings on the chips inside the Vision Pro and discussed the many sensors it has inside and out to monitor the wearer’s face, hands, and surroundings. iFixit noted that the Vision Pro has some modularity, including the battery and the headset straps as well as the light seal cushion. But when it comes to getting into the Vision Pro, it takes “a lot of careful finessing with a heat gun and multiple prying tools” to get it apart without damaging it.

Share.
Exit mobile version